Current software works for both AT and MT cars
It is possible with my front camera kit. By default, it switched to the front camera, but I can just keep the backup camera instead if there is no front camera installed.
@Dylan Sandford why did you try to replace the firmware? Please send an email to support@mx5things.com
Unfortunately, the MAC version of the config software is not working correctly for updates. Only the Windows version must be used for firmware updates. We are working on fixing the MAC software.
The main issue with my design is that it is not adjustable; one fixed position. Not many people will like that.
Are you sure you have IG/ACC module, not ACCPC? I don't have a record that you got it from our store. ACCPC has 6 pin connector on the board IGACC - 8-pin connector on the board.
If you got a cable with 12-pin connectors, it must be made for RHD with 2 wires version. Check your connector before installation. We ship to RHD country modified cables. It is easy to move p...
If the key fob Lock/Unlock buttons act in reverse, this software update can fix it. WS6-ST-v105
@Orin Whitener for Soft Top new firmware here (WS6-ST-v105)
If the key fob Lock/Unlock buttons act in reverse, this software update can fix it. WS6-RF-v105
@yang yang firmware update for AT now available by request
AUTOMATIC ROLL-UP WINDOWS CONTROLLER FOR RF will be produced next month (September 2022). Roof controller - limited stock of 16pc will be available by the end of August 2022, but the next producti...
The current version of firmware is designed for manual transmission only. With automatic, it should work in Park mode only. I can't find locally a test car to implement the version for AT. You can...
Configuration software MS Windows Configuration software version 1.1 USB driver VCP Drivers - FTDI (ftdichip.com Apple macOS Configuration software RFC_NC_config_MacOS To get access to firmware...
@ken chambers are you sure that you have ACC/IG controller, not a previous version ACC only? ACC only has 6 pin Molex connector ACC/IG has 8 pin Molex connector
this error message will show up if communication over the CAN bus was lost for a short period of time for some reason. It could be due to bad contacts. It is nothing harmful to the car, just a warn...
@David N please send an email to info@mx5things.com with your order number.
@David N it is not related to batteries, see post above
It means that one of the black wires (ACC/IG cable) has bad contact, jammed pin, or pushed out. Black wires are just straight connections from one connector to another for a keyless system. if you...