Warning Timer for Turn Signal.

The MX-5 turn signal clicking sound is very quiet. Often times when driving with the top open, it’s easy to forget to turn it off. There are a few discussions and solutions on the Miata forum about this issue. Some solutions that are available on the market require permanent installation with taping car wires.

I decided to make an audible reminder as a plug-n-play module utilizing an OBD port. Because all the car status messages and warning beeps are accessible through a CAN bus, this is the best option, in my opinion.

By reusing my previous boards with CAN microcontroller, I made a very quick prototype.

canbrd

In this implementation, a warning beep is produced by a buzzer located inside the Instrument Cluster, initiated by a CAN message. I chose a 4 short double beeps option. It is the same alarm sound as when you are trying to lock the car with the key inside. Kind of a gentle reminder.

My implementation starts a 40 second timer, only if the car is in motion (above 2mph). This will avoid unnecessary beeping when waiting at an intersection with the turn signal on.

After 40 seconds on the move with active blinker it will beep 4 times and wait another 40 second, and so on.

I designed a simple 3D printed enclosure. My module is now ready to hit the road!

enclosure1

Location of the OBD port in this car is perfect for a footwell light, as well. I decided to integrate my timer with an LED light. Utilizing the CAN bus, I can get the status of door action, so as soon as the door opens – the light goes on. When the door is closed – the light slowly fades to off. And again, there’s no need to tap any extra wires, like in other available solutions. The OBD port has a non switchable power source. There’s no need to start the car to activate the light. The microcontroller has a power saving sleep mode. As soon as the CAN messages stop it goes to sleep (consuming less than 1mA), and it wakes up as soon as CAN activity starts, which is activated by opening the door or pressing buttons on the key fob.

LEDside

installed

 

Next step is to design a production ready board and a more slick enclosure.

To be continue ….

3 thoughts on “Warning Timer for Turn Signal.

  1. Hey nice job. I am the guy who you were emailing with about the canbus messages for the beeping. Another thing you may be able to do is use the Lane Departure Warning message to play the rumbling noise over the car stereo. It will mute one side and play a deep, rumbling noise which may be better since it is much more noticable than a beep on the dash especially if you are driving top down with your music turned up.

    Like

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s