I like the trunk mechanism on the Audi A3 2015 car. The trunk opens all the way up by remote. When you’re carrying groceries it is very convenient. I usually carry two bags for my work commute and the MX-5 trunk will only open an inch or so, causing me to have to put my bags down to open the lid all the way. After a closer look at the current mechanism, I thought it would be easy to add a couple of torsion springs, to help the trunk lid open-up all the way, by remote.
I found on the McMaster good size torsion springs and designed simple brackets to attach them; I 3D printed the brackets from ABS plastic and they seem to do a good job!
Parts from McMaster-Carr (updated):
- 9271K125 – 180 Degree Music-Wire Steel Torsion Spring Left-Hand Wound
- 9271K124 – 180 Degree Music-Wire Steel Torsion Spring Right-Hand Wound
- 94850A129 – No-Slip Clip-On Barrel Nut 1/4″-20 Thread Size – 2
- 8863T23 – Vibration-Damping Loop Clamp, 3/16″ ID, 1-1/8″ Long – 2 (to attach spring to the lid)
- 94779A840 – Head Screws, Black-Oxide, 1/4″-20 Thread Size, 3/4″ Long -2
Updated 3D printed parts are here .
Bracket attached to the hinge with one screw. Spring needs to be cut on one side for 2″
Of course, closing the lid now requires a little more push, but not much. This modification is simple. I really like this new feature in my car.
The latest design does not require you to install a loop clamp on the lid, just a plastic pad on top of the screws.
Updated on 10/1/2017
MX-5 2017 RF has slightly different hinges, to make my design work in both car versions I have designed new plastic parts.
In the RF model, this design works very well, however, the Soft Top version still has some cosmetic issues. The soft top trunk lid is lifted 0.5-2 mm above the body line, the RF seems to not have this problem.
The new document Trunk Lid Popper Installation (updated on 9/20/2019).
The latest design was improved by replacing 3D printed parts with aluminum. Available through my store.
Pingback: Trunk lid liner | Gadgets for my MX-5 2016 (ND)
Installation was easy and works beautiful. Will recommend.
LikeLike
Hello – will this fit and work on the Fiat 124 Spider?
LikeLike
unfortunately it is not compatible for Fiat 124
LikeLike
Hi – will this work with the factory trunk spoiler like on the car below?
LikeLike
I have reports from some customers that it is not working, but others says it is fine. You can try and return if there is an issue.
LikeLike
Have there been any updates to the design regarding the gap on soft-top models, or is there still a .5-2mm gap?
LikeLike
unfortunately nothing we can do with this.
LikeLike
Could you please upload the updated parts to thingiverse?
LikeLike
it’s is genial
LikeLike
Have you solved the issue with the ND softtop. ?
LikeLike
no, it seems some cars are fine, some have a little lift.
LikeLike