MX-5 2016 original wind blocker has a very simple design, and almost useless. It doesn’t block much wind but blocks your view. I decided to replace it with a bigger size acrylic screen…
I created the design using Solidworks and Adobe Illustrator. The mounting clips were 3D printed using ABS plastic. The screen was laser cut from a 4.5mm acrylic sheet, by Ponoko service. The result was a very clean design and easy to install.
The proposed design was discussed on the Miata forum and got many positive feedbacks.
The cut out in the middle section of the wind blocker allows you to open and close the soft top from the driver’s seat. This is very convenient, but some people prefer the efficiency of wind-blocking over convenience, so a bigger size screen was designed.
Ponoko service provides laser etching as well, for custom logo designs. Currently, 8 different options are available for ordering here
See the latest slide show on YouTube.
Pingback: Acrylic Wind Blocker with perfect fit | Gadgets for my MX-5 2016 (ND)
Easy to install , good quality and looks great.
LikeLike
Will you clarify what “arched” and “bowed” tops are? Does arch go upward above horizontal and bowed go downward below horizontal?
LikeLike
correct, “arched” makes higher in the middle and “bowed” lower
LikeLike
Thank you. I wonder if it’s only me that wasn’t sure or if an update to the description might be of benefit to your clients.
LikeLike
also wondering if the 9″ high ones are noisier than the 6.5″ ones
LikeLike
9″ actually reduces noise for 1-2 dB, compare to 6.5″ or without wind blocker
LikeLike